View source for Reflow Soldering (Beta Layout kit)

Connecting to the Beta Layout Flow controller simply with screen:
 screen -L /dev/ttyUSB0
The '-L' argument saves the session to a logfile.

If screen exits without error, check if you have read/write access to /dev/ttyUSB0. If not, run:
 sudo adduser $USER dialout

Settings for Pb soldering:
 phttemp  125 Preheat temperature: [0..254] degC
 phttime  150 Preheat time: [0..65534] Sekunden
 phtpwr   60 Preheat power: [0..100] %
 soaktemp  180 Soak temperature: [0..254] degC
 soaktime   90 Soak time: [0..65534] Sekunden
 soakpwr   80 Soak power: [0..100] %
 reflowtemp  230 Reflow temperature: [0..254] degC
 reflowtime  140 Reflow time: [0..65534] Sekunden
 reflowpwr  100 Reflow power: [0..100] %
 dwelltemp  232 Dwell temperature: [0..254] degC
 dwelltime   40 Dwell time: [0..65534] Sekunden
 dwellpwr   80 Dwell power: [0..100] %
 tempoffset-  10 temperature adjust [-30..30] deg
 debug OFF output debug information [0 or 1]
 trace OFF output internal status information [0 or 1]
 settings   0 select the active parameter set [0..4]


Settings for Sn96.5Ag3Cu0.5 soldering
* Same, but reflowtemp=245;
Boards (tested with PCBway boards) do start to smell, and the areas without copper turn darker (not black yet)