Difference between revisions of "FPGA Test Board"

From Tech
Jump to navigationJump to search
Line 1: Line 1:
 
=TODO=
 
=TODO=
 
==layout==
 
==layout==
  +
* connect spartan-6 to papilio (FTDI, Flash memory, clk, power)
* eagalise:)
 
  +
* make all resistors on papilio 402, check capacitors
 
* add header pins to FLASH SPI, to allow direct programming by raspberry (to work around possible problems in FTDI connections)
 
* add header pins to FLASH SPI, to allow direct programming by raspberry (to work around possible problems in FTDI connections)
 
* add resistor-map to make simple DA converter
 
* add resistor-map to make simple DA converter
 
* add location for oven-controlled crystal
 
* add location for oven-controlled crystal
  +
*
   
 
==questions==
 
==questions==

Revision as of 21:49, 7 December 2013

TODO

layout

  • connect spartan-6 to papilio (FTDI, Flash memory, clk, power)
  • make all resistors on papilio 402, check capacitors
  • add header pins to FLASH SPI, to allow direct programming by raspberry (to work around possible problems in FTDI connections)
  • add resistor-map to make simple DA converter
  • add location for oven-controlled crystal

questions

  • polarity of CCR on Display Port cable? (wiki has pin 7 as +lane_2, wim pin 7 as -CCR) -- Oh, that's because the sink-side has the pinning reversed -- but then the polarity of MR is wrong

Components



Xilinx PCB design guides

Other stuff

Todo/tocheck

  • make papilio output +/- 71MHz differential signal, at several differential voltages.
  • add footprints to eagle
  • can spartan-differential easily be made compatible with rs484?

See Also