FPGA Test Board: Difference between revisions

From Tech
Jump to navigationJump to search
Content deleted Content added
 
(15 intermediate revisions by the same user not shown)
Line 1: Line 1:
=TODO=
=Goals=
* LED<->PhotoDiode tests
==layout==
* 500MS/s scope
* Add few LEDs to spartan 3
* HF (GHz) -> LF mixing, + probes?
* add location for oven-controlled crystal
* HF sending/receiving + direction sensing
* Check layout 25MHz crystal (same as 32MHz papilio?)
* Power connector?

==questions==
* polarity of CCR on Display Port cable? ([http://en.wikipedia.org/wiki/Display_port wiki] has pin 7 as +lane_2, wim pin 7 as -CCR) -- Oh, that's because the sink-side has the pinning reversed -- but then the polarity of MR is wrong


=Components=
=Components=
Line 68: Line 64:
=Other stuff=
=Other stuff=
* SMD291 - FLUX [http://nl.farnell.com/chip-quik/smd291/flux-syringe-10cc-no-clean/dp/1850216?Ntt=1850216 farnell 1850216], [http://www.digikey.com/product-detail/en/SMD291/SMD291-ND/355201 digikey], or [http://www.digikey.com/product-detail/en/SMD291NL/SMD291NL-ND/1160000 5cc]
* SMD291 - FLUX [http://nl.farnell.com/chip-quik/smd291/flux-syringe-10cc-no-clean/dp/1850216?Ntt=1850216 farnell 1850216], [http://www.digikey.com/product-detail/en/SMD291/SMD291-ND/355201 digikey], or [http://www.digikey.com/product-detail/en/SMD291NL/SMD291NL-ND/1160000 5cc]
* SMD291AX solder paste [http://www.farnell.com/datasheets/1376171.pdf datasheet] (the one from digikey is only partly readable)
* Differential impedance calculator [http://www.eeweb.com/toolbox/edge-coupled-microstrip-impedance/ eeweb]
* Differential impedance calculator (wrong results for strip?): [http://www.eeweb.com/toolbox/edge-coupled-microstrip-impedance/ eeweb], [http://www.mantaro.com/resources/impedance_calculator.htm mantaro.com]


=PCB Errors=
=Todo/tocheck=
* NC pins on DisplayPort should have been connected to ground
* make papilio output +/- 71MHz differential signal, at several differential voltages.
* add footprints to eagle
* can spartan-differential easily be made compatible with rs484?


=See Also=
=See Also=

Latest revision as of 14:34, 8 October 2014

Goals

  • LED<->PhotoDiode tests
  • 500MS/s scope
  • HF (GHz) -> LF mixing, + probes?
  • HF sending/receiving + direction sensing

Components



Xilinx PCB design guides

Other stuff

PCB Errors

  • NC pins on DisplayPort should have been connected to ground

See Also