FPGA Test Board: Difference between revisions

From Tech
Jump to navigationJump to search
Content deleted Content added
Line 1: Line 1:
=TODO=
=TODO=
==layout==
==layout==
* Add few LEDs to spartan 3
* make all resistors on papilio 402, check capacitors
* add header pins to FLASH SPI, to allow direct programming by raspberry (to work around possible problems in FTDI connections)
* add location for oven-controlled crystal
* add location for oven-controlled crystal
* Check layout 25MHz crystal (same as 32MHz papilio?)
* Check layout 25MHz crystal (same as 32MHz papilio?)

Revision as of 22:36, 14 December 2013

TODO

layout

  • Add few LEDs to spartan 3
  • add location for oven-controlled crystal
  • Check layout 25MHz crystal (same as 32MHz papilio?)
  • Power connector?

questions

  • polarity of CCR on Display Port cable? (wiki has pin 7 as +lane_2, wim pin 7 as -CCR) -- Oh, that's because the sink-side has the pinning reversed -- but then the polarity of MR is wrong

Components



Xilinx PCB design guides

Other stuff

Todo/tocheck

  • make papilio output +/- 71MHz differential signal, at several differential voltages.
  • add footprints to eagle
  • can spartan-differential easily be made compatible with rs484?

See Also